Posted 19 June 2012 - 08:06 AM
Is this made in Newton 2? It's a very original design, but some of the shapings of the elements could be better, especially that overbank. For the overbank, use multizone force and make the roll into 3 sections, one where it turns into the desired roll angle, one with the roll staying the same, and one with the roll angling out. For the normal zone forces, use two zones, one going down below 1 G, and one going up to the original G force.
Also, not many Intamins have an MCBR, so I suggest you get rid of it and put a small dip in its place. The all you have to do is rework the layout a little bit, but that might be a pain adjusting the final brake run and all that jazz at the end.
I like the design, just make sure you don't use lats, and do use multizone forces for every major element. It might take longer, but the result looks better and will ride better in the end.